EY Series Automatio Self-Cleaning Strainer

EY Series Automatio Self-Cleaning Strainer (FST-EY-01)

Describle:

This type of the self-cleaning filter is a kind of structural form which is designed and developed according to the different installation requirements of pipeline.

The automatic cleaning filter is usually installed at the inlet of pressure reducing valve, pressure relief valve, fixed water level valve or other equipment to remove impurities in the medium.

In order to protect the valve and equipment from normal use, its function is to filter impurities in the water to protect the valve and equipment from normal operation.

Principle of Operation:

The water to be treated enters the body from the inlet, and the impurities in the water deposit on the stainless steel filter, resulting in pressure difference. The pressure difference between the inlet and outlet is monitored by the differential pressure switch. When the pressure difference reaches the set value, the plc electronic control device gives the hydraulic control valve and drives the motor signal, which causes the following actions: the motor drives the brush to rotate, the filter core is cleaned, At the same time, the control valve is opened for discharge, and the whole cleaning process lasts only for tens of seconds. When the cleaning is over, the control valve is closed, the motor stops rotating, the system returns to its initial state, and the system begins to enter the next filtration process.

After installation, the equipment is debugged by technicians, the filtration time and cleaning conversion time are set, the water to be treated enters the body from the inlet, and the filter starts to work normally.

Product Material:

Strainer Body: Carbon Steel (Bituminous Epoxy Paint, Epoxy Coating ),Stainless Steel.

Screen: Stainless Steel, Other special material.

Shaft Components: Stainless Steel, Nylon. PVC Drain Valve: Cast lron, Brass, Stainless Steel.

Product Advantages:

①Short self-cleaning time and small pressure loss.

②Through the finite element analysis, the brush shaft, which is the critical component, obtains the better structure, and strength.

③Inteligent control(PLC), high degree of automation.

④ Suit for various of raw water qualities and requirements.

⑤ Less vulnerable parts, no consumables, less running costs.

⑥Self-cleaning with continuous flow.

⑦Long lifetime.

Performance of EL series strainer:

1. Flow rate of one piece:25-1200m2/h, more discharge can be achieved by more pieces in parallel connection.

2. Maximum operating temperature:70 C, products can be customized for higher temperature.

3. Filtration fineness:100-4500 micron.

4.Operating pressure:1.0MPa,1.6MPa,2.5MPa,4.0MPa.

5. Minimum operating pressure:0.1MPa.

6. Cleaning time:15-60s, cleaning time is set according to actual conditions.

7. Loss of pressure in cleaning:0.01MPa.

8. Control mode: manual, pressure difference or time control.

9.Operating voltage: Three-phase AC 220/380/440V 50/60Hz.

EYstrainer installation schematic:

Contact us if you need more details on Automatio Self-Cleaning Strainer. We are ready to answer your questions on packaging, logistics, certification or any other aspects about Y Type Automatio Self-Cleaning Strainer、Auto Self-Cleaning Filters. If these products fail to match your need, please contact us and we would like to provide relevant information.

Product Categories : Water Filters > Automatic Self-cleaning Filters